Hur man kör ett teckens LCD visar med hjälp av DIP-switchar (1 / 8 steg)
Steg 1: Vad du behöver
* En skärbräda (http://www.protostack.com/index.php?main_page=product_info&cPath=23&products_id=49)
* En HD44780 kompatibel LCD uppvisning (http://www.protostack.com/index.php?main_page=product_info&cPath=24_33&products_id=46)
* 9 dip-switchar (jag använde ett 8 sätt och en 4-vägs, men någon kombination som lägger till 9 eller högre är OK)
* En mikro taktil tryckknapp switch (http://www.protostack.com/index.php?main_page=product_info&cPath=22&products_id=23)
* 10 10K motstånd (http://www.protostack.com/index.php?main_page=product_info&cPath=14_31&products_id=37)
* en 100nF kondensator (http://www.protostack.com/index.php?main_page=product_info&cPath=14_28&products_id=19)
* En 1K trimpot
* 16pin huvud (http://www.protostack.com/index.php?main_page=product_info&cPath=5_9&products_id=32)
* 5V kraftkälla. Protostack 5V power leverans kit kommer att göra susen (http://www.protostack.com/index.php?main_page=product_info&cPath=26&products_id=71) men det finns många andra alternativ för
* Massor av tråd (jag använde cat5)